[SIII XJ6} Fuel Injection bits

[Kroppe <kroppe@mich.com>]

Greetings - 

Does anyone know of a source in the US that sells fuel injection
electrical bits for the SIII XJ6 system (Bosch L-Jetronic)?  I need the
parts which would allow me to rebuild my fuel injection harness.  They
are as follows:

- Plastic connector to fuel injectors and H20 sensors.  Bosch part
number 022 906 231
- Female spade terminals to fit inside above connectors
- Black rubber harness boots to fit above connectors
- Wire of the proper gage and color (with tracers)

The dealer will sell me a harness for about US$350, and a place I found
in California sells the miscellaneous bits for a project total of about
US$275.  I was thinking I could get this done for under US$100, because
I only need 8 connectors, 16 pins and some wire.  Can't be too
expensive, right?

Regarding the bulkhead multi-connector, I would probably leave 4 inches
or so of old wiring, and solder the new harness to the old bulkhead
connector.

Thanks for any and all info.

B.J. Kroppe - '82 XJ6

p.s. If anyone is wondering why I want to rebuild my harness, it's
because alot of the wire insulation is brittle and has cracked off the
wires, leaving exposed conductors.  I am worried, because I can see alot
of this.  That means I probably can't see alot more, due to its being
covered in woven sheating (the black plastic sheathing, not the woven
cotton stuff.  The cotton stuff has all gone bye-bye).

---

Follow-Ups:

• Re: [SIII XJ6} Fuel Injection bits
• From: Hal Rogers <hdrsons@iamerica.net>

---

• Prev by Date: Free software to list
• Next by Date: XK8 AJ-V8 - a few facts
• Prev by thread: RE: Free software to list
• Next by thread: Re: [SIII XJ6} Fuel Injection bits
• Index(es):
  • Main
  • Thread